Crafts parents and kids can enjoy together. Recommended craft ideas to keep children entertained.

Let’s make a bow and arrow

How to make a bow and arrow from a single plastic wrap core (Beginner)

Here’s how to make a bow and arrow from a plastic wrap core! First, poke a hole in the center of the core, then make four vertical cuts along the tube.

Bend the cut middle sections inward on both sides.

Next, use rubber bands and twine to make the bow.

Hook a rubber band onto the indented part of the bow to finish it.

Make the arrows using a bamboo skewer and paper.

Since bamboo skewers are light, be sure to wrap them with paper.

Once your arrows are ready, set up a target and try it out.

You might be surprised at how far they fly.

Make sure small children are careful.

expand_lessRaise the rankingexpand_morelower

kepiko

Report a problem

Marble run with a milk carton and paper plates

[Elementary School Summer Craft/Independent Research] Let’s make a marble run using a milk carton and paper plates!

Let’s make a spiral marble run using a milk carton and paper plates! First, cut off the spout and the bottom of the milk carton and turn it into a cylinder by removing the corners.

Next, cut out the center of a paper plate to make a donut shape, snip one spot to open it up, then make several cuts from the center hole outward.

Wrap these around the milk carton to form slide-like ramps.

It’s a good idea to roll a marble from time to time as you build to check that it rolls properly.

Finally, cut off the bottom third of a paper cup, attach it under the end of the slide, and use it as the catcher—then you’re done!

expand_lessRaise the rankingexpand_morelower

SAKI

Report a problem

Marble coaster made from drawing paper and milk cartons

[Elementary School Craft] Marble Coaster: A Handmade Toy Made with Construction Paper and Milk Cartons

Let’s try making a complex marble run using a milk carton and construction paper! First, close the opening of the milk carton to make a complete cube, then wrap it with construction paper in any color you like.

Next, use construction paper to craft detailed tracks in various shapes.

Make different kinds of paths—curves, sharp angles, and zigzags.

Once the tracks are ready, attach them to the milk-carton cube however you like, and you’re done.

There are no rules for how to build the tracks, so create an original and fun course full of personality!

expand_lessRaise the rankingexpand_morelower

SAKI

Report a problem

A climbing ladybug!

Easy magnet craft! A climbing ladybug! Recycle plastic wrap and toilet paper cores! #crafts #handmadeToys #summerVacationCrafts #recycledCrafts

Here’s how to make a ladybug toy you can play with using magnets.

First, decorate a half-sphere of Styrofoam to look like a ladybug using pens or any materials you like.

Attach a magnet to the back of the ladybug with double-sided tape.

Next, flatten a toilet paper tube and cut it in half.

Use double-sided tape to fix the cut piece around a wooden stick to form a ring, then attach a magnet so it attracts the ladybug’s magnet.

Make a “tree” using a plastic wrap (cling film) tube, and insert the stick inside the tube.

When you move the stick up and down, the ladybug will move too! It’s also fun to make other bugs or your favorite characters instead of a ladybug, so give it a try!

expand_lessRaise the rankingexpand_morelower

kepiko

Report a problem

A climbing ladybug!

Easy magnet craft! A climbing ladybug! Recycle plastic wrap and toilet paper cores! #crafts #handmadeToys #summerVacationCrafts #recycledCrafts

Here’s how to make a ladybug toy you can play with using magnets.

First, decorate a half-sphere of Styrofoam to look like a ladybug using pens or any materials you like.

Attach a magnet to the back of the ladybug with double-sided tape.

Next, flatten a toilet paper tube and cut it in half.

Use double-sided tape to fix the cut piece around a wooden stick to form a ring, then attach a magnet so it attracts the ladybug’s magnet.

Make a “tree” using a plastic wrap (cling film) tube, and insert the stick inside the tube.

When you move the stick up and down, the ladybug will move too! It’s also fun to make other bugs or your favorite characters instead of a ladybug, so give it a try!

expand_lessRaise the rankingexpand_morelower

kepiko

Report a problem

How to make a paper popper

How to Make a Paper Pop Gun [Craft Using a Wrap/Core Tube]

Here’s how to make a simple paper pop gun using a plastic wrap core.

First, roll up some paper to make a small ball about 1 cm in diameter.

Cut a balloon around the middle and attach it to the end of the wrap core.

Secure it with a rubber band so it doesn’t come off, and you’re done! Put the paper ball inside, pull the balloon back, and launch the paper ball you made.

You can also decorate the gun however you like or use cardboard to give it a cool gun shape.

Have fun with your own original ideas!

expand_lessRaise the rankingexpand_morelower

kepiko

Report a problem

How to make a paper popper

How to Make a Paper Pop Gun [Craft Using a Wrap/Core Tube]

Here’s how to make a simple paper pop gun using a plastic wrap core.

First, roll up some paper to make a small ball about 1 cm in diameter.

Cut a balloon around the middle and attach it to the end of the wrap core.

Secure it with a rubber band so it doesn’t come off, and you’re done! Put the paper ball inside, pull the balloon back, and launch the paper ball you made.

You can also decorate the gun however you like or use cardboard to give it a cool gun shape.

Have fun with your own original ideas!

expand_lessRaise the rankingexpand_morelower

kepiko

Report a problem